Key facts
Start here

Dell OptiPlex GX150 System User's Guide
This guide covers Dell OptiPlex GX150 desktop systems in small form-factor, small desktop, and small mini-tower configurations, including front and back panel controls, indicators, and connectors.
It also describes power button behavior, safety information, system setup, hardware upgrades, troubleshooting, technical specifications, and support resources.
Dell GX1 specifications
| Microprocessor | Intel Pentium II or Pentium III |
|---|---|
| Maximum system memory | 768 MB SDRAM |
| Secondary cache | 512 KB SRAM |
| Video memory (GX1p) | 8 MB SGRAM |
| Ethernet controller | Optional 10/100 Mbps 3Com PCI 3C905B-TX NIC |
| Audio controller | 16-bit Crystal CS4236B Plug and Play |
Source: Dell OptiPlex GX1 and GX1p Midsize Managed PC Systems Reference and Installation Guide
All Dell GX1 documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Disassembly, diagnostics and part numbers, for repair.
Questions answered in these manuals
What processors are used in the Dell OptiPlex GX1 and GX1p systems?
The systems use an Intel Pentium II or Pentium III microprocessor.
From: Dell OptiPlex GX1 and GX1p Midsize Managed PC Systems Reference and Installation Guide
How much memory can the OptiPlex GX1 and GX1p support?
System memory can be increased up to 768 megabytes using SDRAM DIMMs in the three DIMM sockets.
From: Dell OptiPlex GX1 and GX1p Midsize Managed PC Systems Reference and Installation Guide
How do you reset the chassis intrusion detector on the Dell OptiPlex GX100?
Enter System Setup and reset Chassis Intrusion to Enabled or Enabled-Silent.
What should you do before working inside the Dell OptiPlex GX100 computer?
Turn off the computer and peripherals, disconnect AC power and telecommunication lines, and wear a wrist grounding strap.
How do I shut down the computer if the operating system is not responding?
Press and hold the power button until the system turns off; if it still does not respond, unplug the AC power cable, wait for the system to stop, and plug it back in.
What does the power indicator show?
No light means the system is off, steady green means normal operation, and blinking green means a low-power state.
