Key facts
- Brand
- DELL
- Model
- PowerConnect 8100 Series
- Category
- Network Switches
- Documents
- 2
- Languages
- EN
- Last added
- 2023-11-22
Start here

Dell N4000 Series and PowerConnect 8100 Series Switch Configuration Guide
This Dell Switch Configuration Guide describes how to configure Dell Networking N4000 Series and Dell PowerConnect 8100 Series switches for use with EqualLogic PS Series storage using Dell best practices. It applies to models N4032, N4032F, N4064, N4064F and PowerConnect 8132, 8132F, 8164, 8164F running firmware 6.0.1.3 and later.
The guide covers hardware setup, deleting the startup configuration, out-of-band management port configuration, login credentials, iSCSI optimization, flow control, jumbo MTU, spanning tree portfast, QSFP LAG ports, and saving the configuration. Optional sections describe Data Center Bridging (DCB) setup and reverting from DCB to non-DCB configuration.
Dell PowerConnect 8100 Series specifications
| FS7610 Fluid File System version | version 3, or later |
|---|---|
| Red Hat Enterprise Linux version | 6.5 or later |
| Windows host version | 2008 R2 with Service Pack 1 or later |
Source: Dell Networking N4000 Series and PowerConnect 8100 Series Planning and Preparation Guide
All Dell PowerConnect 8100 Series documents by type
Mounting, wiring and first power-up. Read it before the hardware goes in.
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
Which host operating systems are supported?
The supported hosts are VMware ESXi, Windows, FS7610 NAS, or Red Hat Enterprise Linux.
From: Dell Networking N4000 Series and PowerConnect 8100 Series Planning and Preparation Guide
What serial cables are required for installation?
A null-modem DB9 serial cable included with the array and a switch serial console management cable included with the switch are required.
From: Dell Networking N4000 Series and PowerConnect 8100 Series Planning and Preparation Guide
What firmware version is supported?
Switch firmware 6.0.1.3 and later is supported.
From: Dell N4000 Series and PowerConnect 8100 Series Switch Configuration Guide
Which Dell switch models are covered?
Dell Networking N4032, N4032F, N4064, N4064F and Dell PowerConnect 8132, 8132F, 8164, 8164F switches.
From: Dell N4000 Series and PowerConnect 8100 Series Switch Configuration Guide
