Winsen MQ-9B Carbon Monoxide Gas Sensor User Manual

Winsen MQ-9B user manual covering the semiconductor CO and methane sensor, technical specifications, test circuits, characteristics, and usage cautions.


Winsen MQ-9B Carbon Monoxide Gas Sensor User Manual - cover page
Brand
Winsen
Category
sensor
Document type
User Manual
Language
Chinese
Pages
7
File format
PDF
File size
452 KB
Published
15 November, 2026
Updated
15 November, 2026
Model
MQ-9B
MD5 checksum
961A9387E00C058F734D6E899C6D1432

About this manual

This manual describes the Winsen MQ-9B semiconductor gas sensor, which uses tin dioxide (SnO2) sensing material and detects carbon monoxide and methane. It explains the high-temperature/low-temperature cycle, with 1.5V heating used to detect CO and 5.0V heating used to clean adsorbed gases.

The document lists product specifications, standard test conditions, the basic test circuit, sensitivity and temperature/humidity characteristic curves, response and recovery behavior, long-term stability, and cautions covering exposure to silicone compounds, corrosive gases, water, condensation, high gas concentrations, vibration, shock, and soldering conditions. This manual is written in Chinese.

What's inside

  • Product Description
  • Technical Specifications
  • Standard Test Conditions
  • Basic Test Circuit
  • Sensor Characteristics
  • Response and Recovery Curves
  • Precautions for Use
  • Soldering Conditions
  • Storage and Aging Time

Specifications

Product typeSemiconductor gas sensor
Detected gasesCarbon monoxide, methane
Detection range10–500 ppm CO; 300–10000 ppm CH4
Loop voltage Vc≤10V DC
Heating voltage VH5.0V±0.1V AC or DC (high temperature); 1.5V±0.1V AC or DC (low temperature)
Heating time60±1 s (high temperature); 90±1 s (low temperature)
Heating resistance RH29Ω±3Ω (room temperature)
Heating power PH≤900 mW
Sensitivity SRs(in air)/Rs(in 150ppm CO)≥5; Rs(in air)/Rs(in 5000ppm CH4)≥3
Output voltage Vs2.5–4.3V (in 150ppm CO); 2.0–4.0V (in 5000ppm CH4)
Standard test temperature and humidity20℃±2℃; 55%±5%RH
Preheating timeNot less than 48 hours
Oxygen content21% (not lower than 18%)
Standard packagePlastic sealed
Load resistance RLAdjustable

Frequently asked questions

What gases does the MQ-9B detect?

The MQ-9B detects carbon monoxide and methane, with detection ranges of 10–500 ppm CO and 300–10000 ppm CH4.

What heating voltages are required for the MQ-9B?

The heater uses 1.5V±0.1V when detecting carbon monoxide and 5.0V±0.1V during the non-detecting recovery stage.

How long must the MQ-9B be preheated before use?

The standard preheating time is not less than 48 hours.

What are the recommended soldering conditions?

Hand soldering is preferred with a constant-temperature iron at 250℃ for no more than 3 seconds, using rosin flux with minimal chlorine.

Download PDF (452 KB)

More Winsen Manuals


View all Winsen manuals →