Winsen MQ-9B Manuals

ManualLib has 2 documents for the Winsen MQ-9B (sensor): 2 user manuals. Every file can be read online or downloaded as a PDF for free.

User Manual 2

Key facts

Brand
Winsen
Model
MQ-9B
Category
sensor
Industry
Electronics
Documents
2
Languages
ZH · EN
Last added
2026-11-15

Start here

Winsen MQ-9B Carbon Monoxide Gas Sensor User Manual

Winsen MQ-9B Carbon Monoxide Gas Sensor User Manual

User Manual 7 pages · 452 KB · ZH

This manual describes the Winsen MQ-9B semiconductor gas sensor, which uses tin dioxide (SnO2) sensing material and detects carbon monoxide and methane. It explains the high-temperature/low-temperature cycle, with 1.5V heating used to detect CO and 5.0V heating used to clean adsorbed gases.

The document lists product specifications, standard test conditions, the basic test circuit, sensitivity and temperature/humidity characteristic curves, response and recovery behavior, long-term stability, and cautions covering exposure to silicone compounds, corrosive gases, water, condensation, high gas concentrations, vibration, shock, and soldering conditions. This manual is written in Chinese.

Read online

Winsen MQ-9B specifications

Product typeSemiconductor gas sensor
Detected gasesCarbon monoxide, methane
Detection range10–500 ppm CO; 300–10000 ppm CH4
Loop voltage Vc≤10V DC
Heating voltage VH5.0V±0.1V AC or DC (high temperature); 1.5V±0.1V AC or DC (low temperature)
Heating time60±1 s (high temperature); 90±1 s (low temperature)
Heating resistance RH29Ω±3Ω (room temperature)
Heating power PH≤900 mW
Sensitivity SRs(in air)/Rs(in 150ppm CO)≥5; Rs(in air)/Rs(in 5000ppm CH4)≥3
Output voltage Vs2.5–4.3V (in 150ppm CO); 2.0–4.0V (in 5000ppm CH4)
Standard test temperature and humidity20℃±2℃; 55%±5%RH
Preheating timeNot less than 48 hours
Oxygen content21% (not lower than 18%)
Standard packagePlastic sealed
Load resistance RLAdjustable

Source: Winsen MQ-9B Carbon Monoxide Gas Sensor User Manual

All Winsen MQ-9B documents by type

User Manual 2

Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.

Questions answered in these manuals

What gases does the MQ-9B detect?

The MQ-9B detects carbon monoxide and methane, with detection ranges of 10–500 ppm CO and 300–10000 ppm CH4.

From: Winsen MQ-9B Carbon Monoxide Gas Sensor User Manual

What heating voltages are required for the MQ-9B?

The heater uses 1.5V±0.1V when detecting carbon monoxide and 5.0V±0.1V during the non-detecting recovery stage.

From: Winsen MQ-9B Carbon Monoxide Gas Sensor User Manual

What gases does the MQ-9B sensor detect?

It detects carbon monoxide (CO) and methane (CH4).

From: Winsen MQ-9B Carbon Monoxide Sensor User Manual

What is the operating voltage for the heater?

The heater operates at 5.0V±0.1V for high temperature and 1.5V±0.1V for low temperature.

From: Winsen MQ-9B Carbon Monoxide Sensor User Manual