SILICON AX1N Series PLC Hardware Manual

About this manual

This document is the hardware manual for the SILICON AX1N Series small programmable logic controllers. It covers essential safety precautions, including design, installation, wiring, and operation guidelines to ensure safe usage and prevent accidents. The manual specifically addresses potential issues with batch transfer instructions and provides detailed notes on operational procedures. This manual is written in Chinese.

What's inside

• Safety Precautions
• Design Considerations
• Installation Precautions
• Wiring Precautions
• Startup and Maintenance
• Disposal
• Batch Transfer Instructions
• Specifications
• Revision History

Frequently asked questions

What specific precautions are required when using the batch transfer instructions FNC 15 (BMOV, BMOVP)?

Users must avoid setting special data registers (D8000 to D8255) in the target address of the batch transfer instructions, unless file registers are configured.

Which transfer instructions should be used instead when writing to special data registers D8000 to D8255?

The transfer instructions FNC 12 (MOV, DMOV, MOV P, DMOV P) must be used for writing to these special data registers.

What are the supported firmware versions for the AX1N Series Programmable Controller?

The manual covers versions V1.00 through V2.10 of the AX1N Series Programmable Controller.