Micro Motion 775 Type Intelligent Wireless Integral THUM Adapter Wiring Supplement

This document provides detailed information about the Micro Motion 775 Type Intelligent Wireless Integral THUM Adapter, including installation considerations, locating the THUM adapter, THUM adapter wiring requirements, wiring the integral THUM adapter, and post-installation and THUM adapter configuration


Micro Motion 775 Type Intelligent Wireless Integral THUM Adapter Wiring Supplement - cover page
Brand
Micro Motion
Category
Wireless connection
Document type
Installation Guide
Language
Chinese
Pages
8
File format
PDF
File size
686 KB
Published
31 October, 2023
Updated
31 October, 2023
MD5 checksum
F749291528E5F462861A6A8E69BF7271

About this manual

This wiring supplement from Micro Motion (高准) covers the Model 775 intelligent wireless integral THUM adapter. It describes what the adapter does, where to position it, what wiring it needs, and how to connect it to a Micro Motion transmitter. The document states that it is not a complete guide to the wireless THUM adapter; for installation and configuration it refers readers to the Smart Wireless THUM Adapter Quick Installation Guide and Reference Manual, available on the Micro Motion product documentation CD or at www.micromotion.com.

The supplement explains that the THUM adapter extends the HART functionality of a transmitter's primary mA output and passes HART data onto a wireless HART network, and that it is mounted integrally on the transmitter using certified thread sealant at a torque of 30–35 ft-lbs. Wiring tables show which adapter wires go to the transmitter terminals for internally powered (active) and externally powered (passive) mA outputs, including the green ground wire and the extra ground screw inside the 2200S housing. Installation considerations cover mounting position, separation from metal surfaces, antenna spacing and hazardous-area precautions. Illustrations show the adapter installed in a 2700 transmitter and a 2200S transmitter, and the transmitter wiring compartment connections. This manual is written in Chinese.

What's inside

  • THUM 适配器概述
  • 安装考虑因素
  • 定位 THUM 适配器
  • THUM 适配器接线要求
  • 危险区域安装时的接线要求
  • 给一体式 THUM 适配器接线
  • 安装后及 THUM 适配器组态

Specifications

Mounting torque30–35 ft-lbs
Minimum antenna separation from personnel7.9" (20 cm)
Voltage drop on signal loop2.25 V at 3.5 mA to 1.2 V at 25 mA, linear
Maximum voltage drop in fault condition2.5 V
Required voltage margin at 250 ohm loadat least 2.5 V
Conduit seal locationwithin 18" (45.7 cm) of the transmitter conduit opening
Recommended mounting positionVertical, straight up or straight down

Frequently asked questions

What does the Micro Motion 775 THUM adapter do?

It extends the HART capability of the transmitter's primary mA output and passes the HART data from the transmitter onto a wireless HART network.

Which wires go to the transmitter mA + and mA – terminals with an internally powered output?

The red wire goes to the mA + terminal and the black wire to the mA – terminal, while the yellow and white wires are spliced to the mA output wiring.

How long should I wait before opening the wiring compartment in a hazardous area?

Wait 5 minutes before opening the transmitter wiring compartment if the transmitter is installed in a hazardous area.

Download PDF (686 KB)

More Micro Motion Manuals


View all Micro Motion manuals →