Owner's manual for a 24V 30A battery charger covering LED indicators, fault codes, specifications, and battery profile codes.
This manual describes operation of a 24V 30A battery charger for AGM, flooded, gel, and lithium batteries. It explains LED indicators for battery capacity and charging profile, the EQ button for flooded/wet batteries, and maintenance and safety warnings.
The manual includes a fault indicator table with causes and solutions, product specifications, and a battery profile code table mapping codes b01-b38 to battery models. It also warns against charging non-rechargeable batteries. This manual is written in Chinese.
| DC output voltage (nominal) | 24V |
|---|---|
| DC output voltage (maximum) | 34V |
| DC output current (maximum) | 30A |
| Applicable battery types | AGM, WET, GEL, Lithium |
| Reverse polarity protection | Electronic protection, auto-reset |
| Short circuit protection | Electronic protection, auto-reset |
| AC input voltage range | 100-240V |
| AC input frequency | 50-60Hz |
| AC input current (maximum) | 10.5A |
| Full-load AC power factor | >0.98 |
| Dimensions | 27.6*19.1*8.5cm |
| Weight | 3.5KG |
| Operating temperature | -40℃ to +65℃ |
| Storage temperature | -40℃ to +70℃ |
| Ingress protection | IP66 |
Press the EQ button for 5 seconds to enter EQ mode, then press it for 5 seconds again to exit.
A fault has occurred; use the fault table to identify the cause and solution.
No, the manual warns not to charge non-rechargeable batteries.
LED1 shows the tens digit and LED4 blinks the ones digit; for profile 35, LED1 is on and LED4 blinks 5 times.