Yaskawa FS100 Error 18: An instruction is included with incorrect intermediate code in expression instruction.

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Alarm code18

An instruction is included with incorrect intermediate code in expression instruction. The manual's first action is: “(1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”

Model
Yaskawa FS100
Display shows
18
Type
Alarm code
Source
Manual p. 240

What 18 means

An instruction is included with incorrect intermediate code in expression instruction. p. 240

Common causes

  • Software operation error occurred p. 240

What to do

  1. (1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 240

If 18 is still not resolved

  • (1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 240
    “(1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
Open the manual at page 240 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 18; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.