Yaskawa FS100 Error 137: Dual drive control specification error

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Error code137

A dual drive control specification error has occurred due to a setting error. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”

Model
Yaskawa FS100
Display shows
Dual drive control specification error (137)
Type
Error code
Source
Manual p. 259

What 137 means

Dual drive control specification error p. 259

Common causes

What to do

  1. (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 259

If 137 is still not resolved

  • If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 259
    “If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
Open the manual at page 259 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 137; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.