Yaskawa FS100 Error 14: Variable information does not exist.

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Alarm code14

Variable information does not exist. The manual's first action is: “(1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”

Model
Yaskawa FS100
Display shows
Variable information does not exist. (14)
Type
Alarm code
Source
Manual p. 239

What 14 means

Variable information does not exist. p. 239

Common causes

  • Software operation error occurred p. 239

What to do

  1. (1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 239

If 14 is still not resolved

  • (1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 239
    “(1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
Open the manual at page 239 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 14; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.