A syntax error was found in the CNT instruction or TMR instruction. The manual's first action is: “(1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
- Model
- Yaskawa FS100
- Display shows
- The syntax in expression instruction is incorrect. (19)
- Type
- Alarm code
- Source
- Manual p. 240
What 19 means
The syntax in expression instruction is incorrect. p. 240
A syntax error was found in the CNT instruction or TMR instruction. p. 118
The number of steps added to a job exceeded 999. p. 176
Common causes
- Software operation error occurred p. 240
What to do
- (1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 240
Before you service the product, read the safety instructions in the manual p. 6.
If 19 is still not resolved
- If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 240 “If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
This page summarises what the manufacturer’s manual says about 19; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.