Error code2
The system failed to generate the RC connect management task. The manual's first action is: “(1)Check the following settings. -Perform the teaching again so that the teaching points are different from one another.”
- Model
- Yaskawa FS100
- Display shows
- Failed in the generation of the RC connect management task. (2)
- Type
- Error code
- Source
- Manual p. 259
What 2 means
Failed in the generation of the RC connect management task. p. 259
Common causes
What to do
- (1)Check the following settings. -Perform the teaching again so that the teaching points are different from one another. p. 259
- (1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 259
If 2 is still not resolved
- (1)Check the following settings. -Perform the teaching again so that the teaching points are different from one another. p. 259 “(1)Check the following settings. -Perform the teaching again so that the teaching points are different from one another.”
- (1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 259 “(1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
This page summarises what the manufacturer’s manual says about 2; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.