Error code1
The IP address is duplicated with the FS100 controller. The manual's first action is: “(1)Check the following settings. -Perform the teaching again so that the teaching points are different from one another.”
- Model
- Yaskawa FS100
- Display shows
- IP address duplicated. (1)
- Type
- Error code
- Source
- Manual p. 259
What 1 means
IP address duplicated. p. 259
Common causes
What to do
- (1)Check the following settings. -Perform the teaching again so that the teaching points are different from one another. p. 259
- (1)Reset the alarm., and then try again. (2)The IP address is duplicated with the FS100 controller. Confirm the IP address of the communication target. (3)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 259
If 1 is still not resolved
- save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure) p. 259 “save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure)”
This page summarises what the manufacturer’s manual says about 1; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.