Yaskawa FS100 Error 3: Failed in the generation of the RC server task.

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Error code3

The system failed to generate the RC server task. The manual's first action is: “(1)Check the following settings. -Perform the teaching again so that the 2ndaxis positions of C3, C4, and C5 of the station axes are the same.”

Model
Yaskawa FS100
Display shows
Failed in the generation of the RC server task. (3)
Type
Error code
Source
Manual p. 259

What 3 means

Failed in the generation of the RC server task. p. 259

Common causes

  • Setting error p. 259
  • Software operation error occurred p. 259

What to do

  1. (1)Check the following settings. -Perform the teaching again so that the 2ndaxis positions of C3, C4, and C5 of the station axes are the same. p. 259
  2. (1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 259

If 3 is still not resolved

  • (2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 259
    “(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
Open the manual at page 259 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 3; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.