Yaskawa FS100 Error 4548: CANNOT OPERATE SPECIFIED EVENT

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Alarm code4548

The system cannot perform the specified event due to a software operation error. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”

Model
Yaskawa FS100
Display shows
CANNOT OPERATE SPECIFIED EVENT (4548)
Type
Alarm code
Source
Manual p. 268

What 4548 means

CANNOT OPERATE SPECIFIED EVENT p. 268

Common causes

  • Software operation error occurred p. 268

What to do

  1. (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 268

If 4548 is still not resolved

  • (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 268
    “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
Open the manual at page 268 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 4548; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.