Siemens G120C Error 6165: A communications error was identified when receiving the PROFIsafe telegram. The fault may also occur if an inconsistent or out-of-date PROFIsafe telegram has been received after switching the Control Unit off and on or after plugging in the PROFIBUS/PROFINET cable.

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault code6165

A communication error occurred while receiving the PROFIsafe telegram on the Siemens G120C, possibly due to outdated or inconsistent data. The manual lists no action for this code.

Model
Siemens G120C
Display shows
6165
Type
Fault code
Source
Manual p. 677

What 6165 means

A communications error was identified when receiving the PROFIsafe telegram. The fault may also occur if an inconsistent or out-of-date PROFIsafe telegram has been received after switching the Control Unit off and on or after plugging in the PROFIBUS/PROFINET cable. p. 677

Common causes

  • - if the fault occurs after powering up or after inserting the PROFIBUS/PROFINET cable, acknowledge the fault. p. 677

If 6165 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 677 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about 6165; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.