Siemens G120C Error 6067: Watchdog time not valid (F_WD_Time).

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault code6067

The watchdog time setting is invalid on the Siemens G120C, and must not be set to 0 at the PROFiSafe slave. The manual lists no action for this code.

Model
Siemens G120C
Display shows
Watchdog time not valid (F_WD_Time). (6067)
Type
Fault code
Source
Manual p. 677

What 6067 means

Watchdog time not valid (F_WD_Time). p. 677

Common causes

  • - check the setting of the value in the F parameter F_WD_Time at the PROFiSafe slave. It is not permissible for the watch time to be 0! p. 677

If 6067 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 677 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about 6067; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.