Siemens G120C Error F01663: SI P1 (CU): Copying the SI parameters rejected

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault codeF01663

The SI parameters could not be copied on the Siemens G120C because p9700 was set to 208 or entered offline. The manual's first action is: “- set p9700 to 0.”

Model
Siemens G120C
Display shows
SI P1 (CU): Copying the SI parameters rejected (F01663)
Type
Fault code
Source
Manual p. 686

What F01663 means

SI P1 (CU): Copying the SI parameters rejected p. 686

Common causes

  • In p9700, the value 208 is saved or was entered offline. p. 686

What to do

  1. - set p9700 to 0. p. 686
  2. - Check p9601 and if required, correct. p. 686
  3. - restart the copying function by entering the corresponding value into p9700. p. 686

Before you service the product, read the safety instructions in the manual p. 4.

If F01663 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 686 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about F01663; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.