Siemens G120C Error 6070: Incorrect F parameter version (F_Par_Version).

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault code6070

The F parameter version is incorrect on the Siemens G120C; it must be set to 0 for V1 mode or 1 for V2 mode at the PROFiSafe slave. The manual lists no action for this code.

Model
Siemens G120C
Display shows
Incorrect F parameter version (F_Par_Version). (6070)
Type
Fault code
Source
Manual p. 677

What 6070 means

Incorrect F parameter version (F_Par_Version). p. 677

Common causes

  • - check the setting of the value in the F parameter F_Par_Version at the PROFiSafe slave. The value for the F parameter version is 0 in the V1 mode and 1 in the V2 mode! p. 677

If 6070 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 677 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about 6070; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.