Siemens G120C Error 6071: CRC error for the F parameters (CRC_1). The transferred CRC value of the F parameters does not match the value calculated in the PROFIsafe driver.

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault code6071

A CRC error occurred in the F parameters on the Siemens G120C, indicating a mismatch between transferred and calculated values. The manual lists no action for this code.

Model
Siemens G120C
Display shows
6071
Type
Fault code
Source
Manual p. 677

What 6071 means

CRC error for the F parameters (CRC_1). The transferred CRC value of the F parameters does not match the value calculated in the PROFIsafe driver. p. 677

Common causes

  • - check the settings of the values of the F parameters and the F parameter CRC (CRC1) calculated from these at the PROFiSafe slave and, if required, update. p. 677

If 6071 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 677 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about 6071; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.