Siemens G120C Error 6072: F parameterization is inconsistent.

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault code6072

The F parameterization is inconsistent on the Siemens G120C, requiring correction of parameter settings. The manual lists no action for this code.

Model
Siemens G120C
Display shows
F parameterization is inconsistent. (6072)
Type
Fault code
Source
Manual p. 677

What 6072 means

F parameterization is inconsistent. p. 677

Common causes

  • - check the settings of the values for the F parameters and, if required, correct. p. 677

If 6072 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 677 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about 6072; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.