Siemens G120C Error 6068: Incorrect SIL level (F_SIL).

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault code6068

The SIL level is incorrect on the Siemens G120C; it must be set to SIL2 at the PROFiSafe slave. The manual lists no action for this code.

Model
Siemens G120C
Display shows
Incorrect SIL level (F_SIL). (6068)
Type
Fault code
Source
Manual p. 677

What 6068 means

Incorrect SIL level (F_SIL). p. 677

Common causes

  • - check the setting of the value in the F parameter F_SIL at the PROFiSafe slave. The SIL level must correspond to SIL2! p. 677

If 6068 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 677 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about 6068; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.