Siemens G120C Error 6066: Source address not valid (F_Source_Add).

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault code6066

The source address is invalid on the Siemens G120C, as it cannot be set to 0 or FFFF at the PROFiSafe slave. The manual lists no action for this code.

Model
Siemens G120C
Display shows
Source address not valid (F_Source_Add). (6066)
Type
Fault code
Source
Manual p. 677

What 6066 means

Source address not valid (F_Source_Add). p. 677

Common causes

  • - check the setting of the value in the F parameter F_Dest_Add at the PROFiSafe slave. It is not permissible for the destination address to be either 0 or FFFF! p. 677

If 6066 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 677 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about 6066; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.