Siemens G120C Error 6000: An internal software error has occurred (only for internal Siemens troubleshooting).

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault code6000

An internal software error occurred on the Siemens G120C, reserved for internal Siemens troubleshooting. The manual lists no action for this code.

Model
Siemens G120C
Display shows
6000
Type
Fault code
Source
Manual p. 677

What 6000 means

An internal software error has occurred (only for internal Siemens troubleshooting). p. 677

Common causes

  • - carry out a POWER ON (switch-off/switch-on). p. 677

If 6000 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 677 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about 6000; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.