Rockwell Automation MicroLogix 1400 Error 10: ERR_SOCKET_UNACCEPT

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code10

The unload bit is set, stopping instruction execution due to invalid data size in the MS6 instruction. The manual's first action is: “None required,”

Model
Rockwell Automation MicroLogix 1400
Display shows
ERR_SOCKET_UNACCEPT (10)
Type
Error code
Source
Manual p. 258

What 10 means

ERR_SOCKET_UNACCEPT p. 258

Common causes

  • The unload bit (ULL) is set, stopping instruction execution. p. 258
  • Socket error during Unaccept operation p. 258
  • Invalid data size in the MS6 instruction. p. 258
  • Access to this file is not granted. p. 258

What to do

  1. None required, p. 258

Before you service the product, read the safety instructions in the manual p. 274.

If 10 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 10; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.