Rockwell Automation MicroLogix 1400 Error 15: ERR_QUE_FULL

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code15

ERR_QUE_FULL indicates a communications channel configuration change while an instruction was running or an invalid family in the service parameter. The manual's first action is: “None required,”

Model
Rockwell Automation MicroLogix 1400
Display shows
ERR_QUE_FULL (15)
Type
Error code
Source
Manual p. 258

What 15 means

ERR_QUE_FULL p. 258

Common causes

  • Communications channel configuration was changed while instruction was in progress. p. 258
  • Firmware use only p. 258
  • Invalid family in the parameter of the service. p. 258

What to do

  1. None required, p. 258

Before you service the product, read the safety instructions in the manual p. 274.

If 15 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 15; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.