Rockwell Automation MicroLogix 1400 Error 13: INVALID_SERVER_TYPE

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code13

INVALID_SERVER_TYPE means the control field length is invalid or the server type in the service parameter is incorrect. The manual's first action is: “Enter a valid length and retry operation.”

Model
Rockwell Automation MicroLogix 1400
Display shows
INVALID_SERVER_TYPE (13)
Type
Error code
Source
Manual p. 258

What 13 means

INVALID_SERVER_TYPE p. 258

Common causes

  • The requested length in the Control field is invalid (either a negative number or a number greater than 82). p. 258
  • Invalid server type in the parameter of the service. p. 258

What to do

  1. Enter a valid length and retry operation. p. 258

Before you service the product, read the safety instructions in the manual p. 274.

If 13 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 13; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.