Rockwell Automation MicroLogix 1400 Error 12: ERR_SOCKET_DELETE

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code12

ERR_SOCKET_DELETE occurs when the source string length is invalid or there's a socket type error during deletion. The manual's first action is: “Enter a valid string length and retry operation,”

Model
Rockwell Automation MicroLogix 1400
Display shows
ERR_SOCKET_DELETE (12)
Type
Error code
Source
Manual p. 258

What 12 means

ERR_SOCKET_DELETE p. 258

Common causes

  • The length of the Source string is invalid (either a negative number or a number greater than 82). p. 258
  • Socket error during Delete operation, p. 258
  • Invalid socket type in the parameter of the service. p. 258

What to do

  1. Enter a valid string length and retry operation, p. 258

Before you service the product, read the safety instructions in the manual p. 274.

If 12 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 12; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.