Rockwell Automation MicroLogix 1400 Error 14: INVALID_TYPE_CODE

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code14

INVALID_TYPE_CODE signifies an ACL instruction closure due to an invalid type code in the service parameter. The manual's first action is: “None required,”

Model
Rockwell Automation MicroLogix 1400
Display shows
INVALID_TYPE_CODE (14)
Type
Error code
Source
Manual p. 258

What 14 means

INVALID_TYPE_CODE p. 258

Common causes

  • Execution of an ACL instruction caused this instruction to close. p. 258
  • Invalid type code in the parameter of the service. p. 258

What to do

  1. None required, p. 258

Before you service the product, read the safety instructions in the manual p. 274.

If 14 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 14; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.