Rockwell Automation MicroLogix 1400 Error 02H: Target node is busy, NAK No Memory retries by link layer exhausted

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code02H

Target node is busy, NAK No Memory retries by link layer exhausted means the target node is unresponsive due to being busy or memory exhaustion. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
02H
Type
Error code
Source
Manual p. 310

What 02H means

Target node is busy, NAK No Memory retries by link layer exhausted p. 310

Common causes

  • Target node is busy, NAK No Memory retries by link layer exhausted. p. 310

If 02H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 02H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.