Rockwell Automation MicroLogix 1400 Error 03H: Target node cannot respond because message is too large

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code03H

Target node cannot respond because message is too large indicates the message size exceeds the target node’s capacity. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
Target node cannot respond because message is too large (03H)
Type
Error code
Source
Manual p. 310

What 03H means

Target node cannot respond because message is too large p. 310

Common causes

  • Target node cannot respond because message is too large. p. 310

If 03H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 03H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.