Rockwell Automation MicroLogix 1400 Error 04H

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code04H

Target node cannot respond because it does not understand command parameters or a control block was modified means the command is invalid or misconfigured. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
04H
Type
Error code
Source
Manual p. 310

What 04H means

Target node cannot respond because it does not understand the command parameters OR the control block may have been inadvertently modified. p. 310

Common causes

  • Target node cannot respond because it does not understand the command parameters OR the control block may have been inadvertently modified. p. 310

If 04H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 04H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.