Rockwell Automation MicroLogix 1400 Error 0BH: Target node does not accept this type of MSG instruction

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0BH

Target node does not accept this type of MSG instruction indicates the target node rejects the message type being sent. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
Target node does not accept this type of MSG instruction (0BH)
Type
Error code
Source
Manual p. 310

What 0BH means

Target node does not accept this type of MSG instruction p. 310

Common causes

  • Target node does not accept this type of MSG instruction. p. 310

If 0BH is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0BH; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.