Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The turning feed rate for thread cutting is too fast. The manual's first action is: “Reduce the spindle speed.”
The calculation result of the variable lead thread is less than 0. The manual's first action is: “Check the G code command and modify the program.”
An error occurs when you repeatedly assign the G51.2 polygon cutting command. The manual lists no action for this code.
There is insufficient arc interpolation points. The manual's first action is: “Check and modify the machining program.”
NURBS interpolation is in error. The manual's first action is: “Check if the G code in the NURBS function complies with the command format.”
This alarm occurs when the system executes G31 during tool radius compensation. The manual's first action is: “Check and modify the machining program.”
An error occurs when the system switches the tool radius compensation to the right or left direction. The manual's first action is: “Check and modify the machining program path.”
The tool compensation path is too short. The manual's first action is: “Check and modify the machining program or the tool radius for compensation.”
The tool path is interfered after tool radius compensation. The manual's first action is: “Check and modify the machining program or the tool radius for compensation.”
Tool radius compensation was enabled while executing an arc interpolation block. The manual's first action is: “Modify the machining program to disable the tool radius compensation during linear interpolation.”
Tool radius compensation was canceled while executing an arc interpolation block. The manual's first action is: “Modify the machining program to disable the tool radius compensation during linear interpolation.”
Tool compensation is interfering with the machining path or calculation error occurred. The manual's first action is: “Check and modify the programmed machining path or the tool radius for compensation.”
The G28 command is not allowed during command transfer operations. The manual lists no action for this code.
The chamfer or rounding command in the program cannot be calculated correctly. The manual's first action is: “Check and adjust the chamfer / rounding command in the G code.”
An emergency stop has been activated on the system. The manual's first action is: “Check if the EMG button is pressed.”