Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
There is an error in the taper calculation used by the thread cutting cycle command, indicating a programming or parameter issue. The manual's first action is: “Modify the G code and check related parameters.”
The G70-G73 thread cycle command did not specify any line number, which is required for execution. The manual's first action is: “Check the G code and add the correct line number.”
The G70-G73 thread cycle command references a line number that does not exist in the program. The manual's first action is: “Check the G code and modify to the correct line number.”
The spindle rotation speed deviates too much from the commanded value and continues to exceed allowable limits, unless Pr436/Pr476 are set to 0. The manual's first action is: “When the parameter (Pr436 and Pr476) is s…
The temperature sensor is reported as faulty, possibly due to incorrect installation or hardware failure. The manual's first action is: “Check if the temperature sensor is installed correctly.”
The temperature sensor is disconnected, likely due to a broken or loose wiring connection. The manual's first action is: “Check if the wiring for the temperature sensor functions normally.”
The system detected that the temperature has exceeded its sensing range, indicating possible overheating or sensor malfunction. The manual's first action is: “Check the sensor's output specification.”
A subroutine was called while the machine was already executing a G code command and included an M96 instruction, which is not allowed during interrupt subroutines. The manual's first action is: “Check whether the sub…
The system detected an illegal M code command when executing a special function triggered by M96, especially if G16, G24, G41, G42 or G51 were involved. The manual's first action is: “Check whether specific G code was…
The usage of the cycle command is incorrect or invalid in the G code for this Delta IA-CNC_Milling machine. The manual's first action is: “Check the G code and modify the cycle command.”
No feed rate has been specified for a cycle command on this Delta IA-CNC_Milling machine. The manual's first action is: “Check the G code and specify the feed rate.”
No spindle speed has been specified for a cycle command on this Delta IA-CNC_Milling machine. The manual's first action is: “Check the G code and specify the spindle speed.”
The G10 parameter range is incorrectly set in the G code on this Delta IA-CNC_Milling machine. The manual's first action is: “Check if the G code parameter range is correct.”
An illegal G10 parameter definition has been used in the G code for this Delta IA-CNC_Milling machine. The manual's first action is: “Check if the G code is used correctly.”
The position error between the master and synchronous axes exceeds acceptable limits on this Delta IA-CNC_Milling machine. The manual's first action is: “Check whether the following error between the slave axis and ma…