Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The G code format is invalid. The manual's first action is: “Check the N label of the machining program again.”
The G code buffer is in error. The manual's first action is: “Reload the machining program or update the firmware.”
An internal program operation error occurred due to memory overlap. The manual's first action is: “Reload the machining program or update the firmware.”
There is a conflict in the servo port settings. The manual's first action is: “Check the parameter settings.”
An error occurs when computing workpiece coordinates. The manual's first action is: “Reset the workpiece coordinates.”
An error occurs when computing workpiece coordinates. The manual's first action is: “Reset the workpiece coordinates.”
An error occurs when computing workpiece coordinates. The manual's first action is: “Reset the workpiece coordinates.”
The name of the loaded file is invalid. The manual's first action is: “Reload the program file.”
The G code file is not found. The manual's first action is: “Check the file contents.”
The G code length is illegal. The manual's first action is: “Check the machining program.”
An overspeed motion command has been issued. The manual's first action is: “Make sure the parameter settings are not set too high, such as the output gear ratio and cutting speed setting.”
Position feedback did not change when motion command was issued. The manual's first action is: “Confirm servo settings; for example, the torque limit value is too small.”
The system prevents Servo On / Off action due to position overflow on specified axis during AUTO mode. The manual's first action is: “Check the servo parameters for preventing position overflow.”
Spindle voltage output does not match the motor rotation direction. The manual's first action is: “Check whether the spindle encoder OA/OB wiring is correct.”
The NC parameter is in error. The manual's first action is: “Make sure no parameter values are set to 0, such as the encoder pulse number, the gear numbers of the output shaft and motor.”