Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The tool magazine axis number is not defined or defined repeatedly. The manual's first action is: “Check the parameter settings.”
The NC parameter does not exist or the MLC is not ready. The manual's first action is: “Restart the CNC controller, update firmware, or send the controller back for servicing.”
The NC parameter does not exist or the MLC is not ready. The manual's first action is: “Restart the CNC controller, update firmware, or send the controller back for servicing.”
The NC system command is in error. The manual's first action is: “Check the machining program or the macro content.”
The system encountered an error reading the I/O board hardware interface, requiring servicing of the CNC controller. The manual's first action is: “Send the CNC controller back for servicing.”
An I/O board hardware interface error has occurred, requiring servicing of the CNC controller. The manual's first action is: “Send the CNC controller back for servicing.”
System firmware update failed, requiring power reset and checking for model error, incorrect format, unsupported version, or other conditions. The manual's first action is: “After checking the following conditions, re…
Automatic firmware update is set but requires reboot; the firmware file must be placed in the [pkt] folder on a USB disk. The manual's first action is: “Cycle the power to start the automatic firmware update function.…
Full backup export failed due to remote enablement failure, requiring check of operating mode and correct device installation. The manual's first action is: “Check the operating mode. Make sure the backup storage devi…
Full backup import failed because remote enablement was unsuccessful, requiring check of operating mode and correct device installation. The manual's first action is: “Check the operating mode. Make sure the backup st…
The system reset failed due to no response from the bottom layer, requiring firmware update or servicing. The manual's first action is: “Update the CNC controller firmware or send the controller back for servicing.”
Network communication initialization failed, requiring check of network connection or status. The manual's first action is: “Check the network connection or connection status.”
A network connection error has occurred, requiring check of network status or connectivity. The manual's first action is: “Check the network connection or connection status.”
The TCP/IP driver failed to load with the software panel, requiring an update to reload it. The manual's first action is: “Update the software panel to reload the external device driver.”
An error occurred while attempting to create a COM port, requiring update of the software panel and correct configuration of the external link file. The manual's first action is: “Update the software panel and make su…