Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
EEPROM data is inconsistent, indicating incorrect parameter storage or write failure. The manual lists no action for this code.
Safe torque off (STO) was activated by hardware due to a drive fault. The manual's first action is: “OFF 2 (OFF 3). Quit fault eg. via DI2 • r0948 = 33: passivated STO acknowledge after a drive fault requires the OFF …
Belt failure or mechanical fault has been detected based on load conditions. The manual's first action is: “Check the following: • No breakage, seizure or obstruction of drive train. • If using an external speed senso…
PID autotuning is currently running on the controller. The manual's first action is: “Alarm disappears when PID Autotuning has finished.”
Both JOG left and right commands are active simultaneously, freezing the output frequency. The manual's first action is: “Do not press JOG right and left simultaneously.”
No load is applied to the inverter, causing some functions to behave abnormally. The manual's first action is: “Check that motor is connected to inverter.”
AO parameters are incorrectly set and must be adjusted to avoid illogical results. The manual's first action is: “Check the following: • Parameter settings for output identical • Parameter settings for input identical…
DC-link voltage has dropped below minimum level, triggering the Vdc-min controller for deceleration. The manual lists no action for this code.
The DC-link voltage is being controlled to stay within limits due to active Vdc-max controller. The manual's first action is: “Check the following: • Supply voltage must lie within limits indicated on rating plate. • …
PROFIBUS lost subscriber information, indicating a link failure or communication issue. The manual's first action is: “temporary, if permanent the fault detection is activated”
PROFIBUS received no control word 1, suggesting a transmission problem on the bus. The manual's first action is: “check bus transmission”
PROFIBUS detected no bus connection, indicating a hardware or cable issue. The manual's first action is: “check the cables and the bus hardware”
PROFIBUS error due to a problem with the double word reference table. The manual's first action is: “power cycle”
PROFIBUS: Parameter or configuration error occurs when wrong parameter or configuration telegrams are received via PROFIBUS. The manual's first action is: “check parameter and/or configuration telegram”
RTOS Overrun Warning indicates internal time slice overruns requiring service department contact. The manual's first action is: “Contact Service Department”