Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
All 15 error codes of the Heraeus UT6P, UT12P, UT20P laboratory air circulation oven with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Wrong safety checksum indicates an attempt to exit safety commissioning with mismatched checksum values for safety parameters. The manual lists no action for this code.
Denial of paramet. change means the drive failed to finalize safety parameters, due to incorrect password or tolerance settings. The manual lists no action for this code.
Fault at processor reset indicates a timeout issue during safety reset on either P1 or P2 processor. The manual lists no action for this code.
Fault in safety paramet. means an error occurred during startup, safety commissioning, reset, or internal parameter transfer. The manual lists no action for this code.
Internal software error occurs when there is a buffer overflow during checksum calculation for safety parameters or an endless safety loop. The manual lists no action for this code.
PROFiSafe Driver Fault means an error has been detected in the PROFiSafe driver, such as incorrect parameterization or consecutive number errors. The manual's first action is: “Check PROFiSafe parameters.”
Safe Brake Control faulty indicates a detected error with the brake feedback or internal safety brake module issues. The manual lists no action for this code.
Communication between processors P1 and P2 is inconsistent due to counter synchronization error. The manual lists no action for this code.
Processor self-test failed, indicating internal hardware or memory errors. The manual lists no action for this code.
Control board experienced a hardware environment error, such as voltage or temperature issues. The manual lists no action for this code.
Frequency estimation circuit detected inconsistency in frequency measurement between processors. The manual lists no action for this code.
Maximum frequency limit was exceeded by the drive system. The manual lists no action for this code.
Hardware detection error occurred during startup or runtime on the processor. The manual lists no action for this code.
Cross comparison between processors failed, suggesting communication or processing issues. The manual lists no action for this code.