Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
All 25 error codes of the Grundfos CUE CUE frequency converter with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Reference values are erroneous on this Heraeus UT6P, UT12P, or UT20P unit. The manual's first action is: “contact the service center.”
Stored data is defective on this Heraeus UT6P, UT12P, or UT20P unit. The manual's first action is: “contact the service center.”
Temperature sensor or input is defective on this Heraeus UT6P, UT12P, or UT20P unit. The manual's first action is: “contact the service center.”
Actual temperature falls below lower-limit tolerance on this Heraeus UT6P, UT12P, or UT20P unit. The manual's first action is: “contact the service center.”
Actual temperature exceeds upper-limit tolerance on this Heraeus UT6P, UT12P, or UT20P unit. The manual's first action is: “contact the service center.”
Error in reference values measurement on this Heraeus UT6P, UT12P, or UT20P unit. The manual's first action is: “contact the service center.”
Stored data is defective on this Heraeus UT6P, UT12P, or UT20P unit. The manual's first action is: “Switch the unit off and on again. If the problem persists, contact the service center.”
Termination command restarts the program from the beginning when ending a programmed function on this Heraeus UT6P, UT12P, or UT20P unit. The manual lists no action for this code.
Termination command shuts off heating and ventilation when ending a programmed function on this Heraeus UT6P, UT12P, or UT20P unit. The manual lists no action for this code.
Termination command holds the last set temperature when ending a programmed function on this Heraeus UT6P, UT12P, or UT20P unit. The manual lists no action for this code.
Program segment is active while the added-feature program is running on this Heraeus UT6P, UT12P, or UT20P unit. The manual lists no action for this code.
Program segment is active while the added-feature program is running on this Heraeus UT6P, UT12P, or UT20P unit. The manual lists no action for this code.
The control unit has disabled heating and ventilation for this Heraeus UT6P, UT12P, or UT20P unit. The manual lists no action for this code.
Control unit test phase is active on this Heraeus UT6P, UT12P, or UT20P unit. The manual lists no action for this code.