Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
System fault occurs due to an operation malfunction or defective component, requiring a reset attempt followed by distributor contact if recurring. The manual's first action is: “Reset the fault and start the drive ag…
Saturation trip fault indicates a defective brake resistor, short-circuit, or overload condition that cannot be reset and requires power shutdown. The manual's first action is: “This fault cannot be reset from the con…
Emergency stop is triggered when a stop signal is received from the option board. The manual's first action is: “Do a check of the emergency stop circuit.”
Charging switch fault occurs when the charging switch is open during start command or due to an operation malfunction with a defective component. The manual's first action is: “Reset the fault and start the drive agai…
Overvoltage happens when the DC-link voltage exceeds limits, often caused by too short deceleration time or high overvoltage spikes in the supply. The manual's first action is: “Set the deceleration time longer. Use t…
Overcurrent occurs when there is too high a current in the motor cable, possibly due to a sudden heavy load increase or a short circuit in the motor cables. The manual's first action is: “Do a check of the loading. Do…
All 21 error codes of the Vacon NXS/P AC drive with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
There is a display connection issue, if other solutions fail. The manual's first action is: “Reconnect the display cable on both the system board side and the computer display side (service provider only).”
There is a problem with the discrete graphics card, if other solutions fail. The manual's first action is: “Reinstall or replace the discrete graphics card (service provider only).”
There is an error with the integrated graphics. The manual's first action is: “Replace the system board (service provider only).”
The platform reset has not been de-asserted. The manual's first action is: “1. Remove all power resources (the ac power adapter and removable battery).”
The machine UUID is invalid, or the cooling fan has failed, or the thermal sensor has a problem. The manual's first action is: “Have the computer serviced.”
The machine type and serial number are invalid. The manual's first action is: “Have the computer serviced.”
The M.2 solid-state drive is not working. The manual's first action is: “Have the M.2 solid-state drive serviced.”
The M.2 solid-state drive is not working. The manual's first action is: “Have the M.2 solid-state drive serviced.”