Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
DOSS fault occurs when DOSS connection on PCB is compromised. The manual lists no action for this code.
Drive fault indicates issues with fuse, motor connection, or drive circuit. The manual lists no action for this code.
Not enough power supplied to the operator occurs if batteries or PSU are faulty and cannot run from PSU alone. The manual lists no action for this code.
Collision alerts when there are obstructions in door tension or guide rails. The manual lists no action for this code.
Current Sensor indicates the door is too heavy for current force setting, requiring adjustment of offset value. The manual lists no action for this code.
Run Time Exceeded occurs if an incorrect door type (SE or tu) is selected. The manual lists no action for this code.
Door Imbalanced triggers when the Door Service monitor detects imbalance. The manual lists no action for this code.
Safety Strip Advice is not applicable to SA operators. The manual lists no action for this code.
Safety Beam Active indicates the safety beams are active, requiring alignment or connection checks. The manual lists no action for this code.
All 10 error codes of the Centurion Systems SDO4 garage door operator with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The electronic insert has lost its calibration data. The manual's first action is: “Contact Endress+Hauser service”
Current output is currently in simulation mode. The manual's first action is: “Set current output to normal mode”
Simulation mode is active on the device. The manual's first action is: “Switch off simulation”
Level simulation has been activated on the device. The manual's first action is: “Switch off level simulation”
The current turn-down calibration is faulty. The manual's first action is: “Repeat calibration”