Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
A second encoder timed out, likely due to an unconnected encoder or loose plug contact. The manual's first action is: “7300-0207h”
The encoder timed out, possibly because it is disconnected or has a loose plug connection. The manual's first action is: “7300-0206h”
A short frame error was detected in the encoder data, likely caused by an unconnected encoder or loose plug contact. The manual's first action is: “7300-0205h”
A frame error occurred with the encoder, possibly due to a disconnected encoder or loose plug contact. The manual's first action is: “7300-0204h”
A CRC error was detected in the encoder data, likely caused by an unconnected encoder or loose plug contact. The manual's first action is: “7300-0203h”
A parity error occurred in the encoder data, possibly due to a disconnected encoder or loose plug contact. The manual's first action is: “7300-0202h”
The encoder feedback deviation is too large, likely because the encoder is not connected or has loose contacts. The manual's first action is: “7300-0201h”
The encoder is offline due to being disconnected or having loose plug contacts. The manual's first action is: “7300-0200h”
A brake pipe fault has been detected for models 7.5kW or above, indicating a brake unit malfunction. The manual's first action is: “FF01-0101h”
An IGBT fault has occurred because the drive’s actual output current exceeds the specified limit, requiring removal of motor cables and replacement if the fault persists. The manual's first action is: “FF01-0100h”
A check error has occurred due to a CRC bit issue in RTU communication. The manual lists no action for this code.
The received data value is outside the allowed range, making parameter modification invalid. The manual lists no action for this code.
The data address requested by the upper computer is invalid, especially if the register address and transmitted byte combination are incorrect. The manual lists no action for this code.
The function code received by the upper computer is not allowed for operation, possibly because it applies only to new devices or is handled incorrectly by the slave node. The manual lists no action for this code.
All 109 error codes of the INVT DA180 AC servo drive with their meaning, causes and what to do, taken from the manufacturer's manual with page references.