Olympus ESG-400 Error E390: Communication error

Electrosurgical generator · taken from the manufacturer’s manual, pages cited

Error codeE390

E390 indicates a communication error between the device and its peripherals. The manual's first action is: “Check the connection of the communication cables to the electrosurgical generator and / or to the peripheral equipment for correct connection.”

Model
Olympus ESG-400
Display shows
Communication error (E390)
Type
Error code
Source
Manual p. 124

What E390 means

Communication error p. 124

Common causes

  • Improper connection of the communication cables to the LINK-OUT / LINK-IN socket on the rear panel of the electrosurgical generator or to the peripheral equipment. p. 124
  • Malfunction or damage of the communication cables. p. 124
  • Malfunction of the electrosurgical generator. p. 124

Safety warnings — read before you start

  • DANGERImportant Information – Please Read Before Use. High frequency leakage current or spark discharge may cause user and / or patient burns. Always prepare for an emergency operation in case of unintentional patient burn, bleeding and perforation. p. 9

What to do

  1. Check the connection of the communication cables to the electrosurgical generator and / or to the peripheral equipment for correct connection. p. 124
  2. Check the cables for damages and, if necessary, replace the cables. p. 124
  3. Contact Olympus. p. 124

If E390 is still not resolved

  • Contact Olympus. p. 124
    “Contact Olympus.”
Open the manual at page 124 All ESG-400 error codes Manual details & download

This page summarises what the manufacturer’s manual says about E390; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Olympus. Found a mistake? Report an error.