Ningbo Anson Hi Series Error Er054: Over-heated Heatsink

Servo drive · taken from the manufacturer’s manual, pages cited

Error codeEr054

Over-heated Heatsink occurs due to high ambient temperature, surrounded heated objects, or cooling fan stopping. The manual's first action is: “1.Check whether the ambient temperature is too high.”

Model
Ningbo Anson Hi Series
Display shows
Over-heated Heatsink (Er054)
Type
Error code
Source
Manual p. 85

What Er054 means

Over-heated Heatsink p. 85

Common causes

  • 1.Ambient temperature is too high. p. 85
  • 2.Surrounded heated objects. p. 85
  • 3.The cooling fan stops running. p. 85
  • 4.Seek for technical support. p. 85

What to do

  1. 1.Check whether the ambient temperature is too high. p. 85
  2. 2.Air duct blockage or damage of fan p. 85
  3. 3.Check sure if the detection sensor is damaged. p. 85
  4. 4.Seek for technical support. p. 85

If Er054 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.

Open the manual at page 85 All Hi Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about Er054; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.