Ningbo Anson Hi Series Error Er053: Software undervoltage

Servo drive · taken from the manufacturer’s manual, pages cited

Error codeEr053

Software undervoltage happens when there’s a three-phase A.C. device instant outage, input power wires are loose, or rectifier bridge and buffer resistance are abnormal. The manual's first action is: “1.Check the wiring.”

Model
Ningbo Anson Hi Series
Display shows
Software undervoltage (Er053)
Type
Error code
Source
Manual p. 85

What Er053 means

Software undervoltage p. 85

Common causes

  • 1.Three phase A.C device's instant outage occurs. p. 85
  • 2.The wires of input power is loose too large. p. 85
  • 3.Check whether the rectifier bridge and buffer resistance is normal. p. 85
  • 4.Check PU.00 to confirm the setting of model, if PU.00 has no data, please set PU.10 and PU.09 p. 85
  • 5.Capacity code hasn't been set. p. 85
  • 6.Seek for technical support. p. 85

What to do

  1. 1.Check the wiring. p. 85
  2. 2.Check whether it's instant power failure damaged. p. 85
  3. 3.Check whether the rectifier bridge and buffer resistance is normal. p. 85
  4. 4.Check PU.00 to confirm the setting of model, if PU.00 has no data, please set PU.10 and PU.09 p. 85
  5. 5.Capacity code hasn't been set. p. 85
  6. 6.Seek for technical support. p. 85

If Er053 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.

Open the manual at page 85 All Hi Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about Er053; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.