Error codeEr084
Non-finished self-searching notch position happens when former notch position self-searching hasn’t finished. The manual's first action is: “Clean the error, do notch position searching once again”
- Model
- Ningbo Anson Hi Series
- Display shows
- Non-finished self-searching notch position (Er084)
- Type
- Error code
- Source
- Manual p. 86
What Er084 means
Non-finished self-searching notch position p. 86
Common causes
- Former notch position self-searching hasn't finished. p. 86
What to do
- Clean the error, do notch position searching once again p. 86
If Er084 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.
This page summarises what the manufacturer’s manual says about Er084; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.