Ningbo Anson Hi Series Error Er122: Error setting of motor model DR.01

Servo drive · taken from the manufacturer’s manual, pages cited

Error codeEr122

Error setting of motor model DR.01 occurs due to unconnected communication lines, loose connections, internal circuit abnormality, or missing motor model setup. The manual's first action is: “1. Check the wiring 2. Seek for technical support”

Model
Ningbo Anson Hi Series
Display shows
Error setting of motor model DR.01 (Er122)
Type
Error code
Source
Manual p. 86

What Er122 means

Error setting of motor model DR.01 p. 86

Common causes

  • 1. The communication line is not connected. 2. Communication lines are loose. 3. The internal circuit is abnormal. p. 86
  • The setting of motor model DR.01 hasn't been done. p. 86

What to do

  1. 1. Check the wiring 2. Seek for technical support p. 86
  2. Before writing UD.03 to 11, please set the DR.01 p. 86

If Er122 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.

Open the manual at page 86 All Hi Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about Er122; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.