Ningbo Anson Hi Series Error Er129: CAN bus communication is wrong.

Servo drive · taken from the manufacturer’s manual, pages cited

Error codeEr129

CAN bus communication is wrong because baud rate is incorrectly set or electromagnetic interference is too large. The manual's first action is: “1. Check the baud rate setting 2. Check the grounding, eliminate the interference”

Model
Ningbo Anson Hi Series
Display shows
CAN bus communication is wrong. (Er129)
Type
Error code
Source
Manual p. 86

What Er129 means

CAN bus communication is wrong. p. 86

Common causes

  • 1. The baud rate is set incorrectly. 2. Electromagnetic interference is too large. p. 86

What to do

  1. 1. Check the baud rate setting 2. Check the grounding, eliminate the interference p. 86

If Er129 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.

Open the manual at page 86 All Hi Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about Er129; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.