Industrial

This document describes the features and characteristics of the MBRF830CT to MBRF8100CT series of isolated 8.0 amp Schottky barrier rectifiers, including the use of plastic material, metal silicon junction, low power loss, high efficiency, high current capability, low forward voltage drop, high surge capability, and applications in low voltage, high frequency inverters, free wheeling, and polarity protection.

This document provides specifications of MBR16Hxx, MBRFH16Hxx and MBRB16Hxx power modules.

The TL�F�6557 54174�DM54174�DM74174� 54175�DM54175�DM74175 Hex�Quad D Flip-Flops with Clear is a positive-edge triggered flip-flops that utilize TTL circuitry to implement D-type flip-flop logic.

This is a datasheet for DM74174 Hex/Quad D-Type Flip-Flop with Clear. The flip-flops utilize TTL circuitry to implement D-type flip-flop logic and have a direct clear input. Information at the D inputs meeting the setup and hold time requirements is transferred to the Q outputs on the positive-going edge of the clock pulse. Clock triggering occurs at a particular voltage level and is not directly related to the transition time of the positive-going pulse. When the clock input is at either the HIGH or LOW level, the D input signal has no effect at the output. The product contains six flip-flops with single-rail outputs and features buffered clock and direct clear inputs.

the 54173~dm54173~dm74173 series of four-bit tri-state registers have three-state outputs that can drive high-impedance loads and low-impedance loads without the need for interface or pull-up components to drive the bus lines in a bus-organized system

MB98A51121/51221/51321/51421/51521-17 is a MASK ROM card released by Fujitsu Semiconductor. It has a 68-pin two-piece interface, supports PCMCIA Rel.2/JEIDA Ver.4, supports 8-bit × 16-bit configuration, external dimensions are 85.6 mm × 54.0 mm × 3.3 mm, working voltage is +5 V, static operation, output tri-state, no pull-up resistor or pull-down resistor.

This is the datasheet of DM7417 Hex Buffers with High Voltage Open-Collector Outputs chip produced by Fairchild Semiconductor Corporation. The chip contains six independent gates, each of which performs a buffer function. External pull-up resistors are used for proper logical operation.

This document describes the features and characteristics of the TL�F�9782 54165�DM74165 8-bit parallel-to-serial converter, which has asynchronous parallel loading and serial input register capabilities.

DM74164 is an 8-bit serial in/parallel out shift register produced by Fairchild Semiconductor Corporation. It has gated serial inputs and asynchronous clear function, which can completely control the input data.

DM54161, DM74161 and DM74163 are synchronous programmable 4-bit counters with internal carry look-ahead for applications in high-speed counting designs.

The MAX6501-MAX6504 are low-cost, fully integrated temperature switches that assert a logic signal when their die temperature crosses a factory-programmed threshold. Operating from a +2.7V to +5.5V supply, these devices feature two on-chip, temperature-dependent voltage references and a comparator. They are available with factory-trimmed temperature trip thresholds from -45°C to +115°C in 10°C increments, and are accurate to ±0.5°C (typ) or ±6°C (max). These devices require no external components and typically consume 30µA supply current. Hysteresis is pin-selectable at +2°C or +10°C. The MAX6501/MAX6503 have an active-low, open-drain output intended to interface with a microprocessor (µP) reset input. The MAX6502/MAX6504 have an active-high, push-pull output intended to directly drive fan-control logic. The MAX6501/MAX6502 are offered with hot-temperature thresholds (+35°C to +115°C), asserting when the temperature is above the threshold. The MAX6503/MAX6504 are offered with cold-temperature thresholds (-45°C to +15°C), asserting when the temperature is below the threshold. The MAX6501-MAX6504 are offered in eight standard temperature versions; contact the factory for pricing and availability of nonstandard temperature versions. They are available in 5-pin SOT23 and 7-pin TO-220 packages.

DM7416 is a hex inverting buffer with high voltage open-collector outputs. Each buffer performs the logic INVERT function, and external pull-up resistors are required for proper logical operation.

54157 is a dual 2-line to 1-line data selector/multiplexer produced by National Semiconductor Corporation

DM74157 is a four-way two-line to one-line data selector/multiplexer produced by Fairchild Semiconductor Corporation. It has buffered inputs and outputs, a typical propagation time of 9ns, and a typical power consumption of 150mW.